The Drive Harness is a car safety harness that will secure your dog whilst in transit.
The Drive Harness ensures compliancy with Rule 57 of the highway code which requires that dogs should not be free to move about in a vehicle -"When in a vehicle make sure dogs or other animals are suitably restrained so they cannot distract you while you are driving or injure you, or themselves, if you stop quickly. A seat belt harness, pet carrier, dog cage or dog guard are ways of restraining animals in cars.”
A SAFETY RESTRAINT FOR DOGS IN CARS
BEST DOG HARNESS FOR CAR TRAVEL
Simply feed the seat belt through both webbing handles on the top of the harness, click the buckle into the seatbelt of your car and you're ready for the Drive.
This Dog Travel Harness is also equipped with double stainless steel D-rings to escort your dog to and from the vehicle.
SIMPLE, ONE TIME FIT
You only have to fit the harness to your dog once (see 'Size and Fitting’ tab above). From then on, the Harness can be taken on/off very quickly using the Mag-Lok™ Instant Fit closure system.
ENGINEERED TO LAST
We have used only the strongest and highest quality materials in this product. The Tri-Glides are made from Aluminium Alloy, so are light, durable and incredibly strong.
All webbing is made from seat belt webbing and the Crosslink™technology ensures the harness is of utmost strength.
The Chest Plate section is padded and contoured to mould to the shape of your dog for a comfortable and custom fit.
Please Read Before Purchase:
At EzyDog we make every effort to manufacture the best products to protect your pet, however there are no official standards or test requirements for Car Canine Safety products.
We have chosen to base our product designs such that they conform to a combination of global child safety and vehicle interior standards. We then test our product and obtain conformance using these standards as a guide.
The final decision on the purchase and use of our Drive Car Harness for the protection of your pet is up to your own judgement and EzyDog will not accept liability for any injuries or damage associated with the use of our product.
Quick, one-time fit
Double D-Rings for lead attachment
Mag-Lok™ Instant Fit closure system
Ergonomic, moulded chest plate
Regularly inspect your harness for any signs of damage and excessive wear including:
Chew and bite marks
ALWAYS REPLACE HARNESS IF SHOWING SIGNS OF DAMAGE
Hand wash in mild detergent and air dry in shade.
Store in a dry place, out of direct sunlight
For best fit measure the girth of your dog. This is the area behind the front legs and around the body. The neck will typically fall into place once the girth is determined. If the measurement is close to the end of the size range, go up to the larger size.
28 - 64
11 - 25
38 - 86
15 - 34
49 - 106
19 - 42
Refer to the Product Video tab above for the Fitting Guide Video.
1.UNLACE AND LOOSEN WEBBINGS FROM ALLOY TRI GLIDE. PLACE HARNESS ON DOG
2.ADJUST BOTH FRONT CHEST WEBBINGS TO A FIRM FIT. USE MEASUREMENTS TO BALANCE WEBBING LENGTHS REPEAT ADJUSTMENT TO REAR GIRTH WEBBINGS
3.LOCK ALL FOUR WEBBINGS IN PLACE BY FEEDING BACK THROUGH ALLOY TRIGLIDE
4.FEED WEBBING TAIL UNDER WEBBING KEEPER AND LOCATE KEEPER BACK AGAINST TRIGLIDE. FOLD EXCESS WEBBING AND SECURE IN KEEPER
5.PLACE FITTED HARNESS ON DOG AND POSITION IN CAR. THREAD SEAT BELT THROUGH BOTH HANDLES AND CLICK INTO BUCKLE. REMOVE SLACK FROM SEAT BELT
IMPORTANT: DO NOT OVER-TIGHTEN STRAPS! WHEN FITTED CORRECTLY, HARNESS SHOULD BE SNUG, BUT TWO FINGERS SHOULD EASILY RUN BETWEEN STRAPS & DOG.